TPS Hall effect Manual

TPS Calibration Instructions:

1️⃣ Turn off the bike and replace the sensor 🛑🔧

2️⃣ Switch the ignition ON (do not start the engine) 🔑⚡

3️⃣ Check the dashboard for errors. If there are no errors, continue 👀✔️

4️⃣ Slowly twist the throttle fully open, hold for 2 seconds, then release it smoothly back and wait another 2 seconds 🏍️➡️⏱️⬅️⏱️

5️⃣ Repeat this motion 3 to 5 times 🔄3️⃣-5️⃣

6️⃣ Turn off the ignition and wait about 20–30 seconds ⏳🔌

7️⃣ Start the bike and go for a test ride 🚀🏍️💨

⚠️ Note: On some models, it may also be necessary to perform an adaptation/calibration via software diagnostics to ensure proper TPS operation. 💻🔧